Measuring over three feet in length, the Pro Boat ShockWave 36 is a ready-to-run deep-vee speedster that can reach speeds up to 35 mph. The power comes from the installed Dynamite .32 Marine engine. The Dynamite .32 Marine is water-cooled and comes equipped with a convenient pull-starter and high performance tuned exhaust system. Control is provided by JR's trusty Python radio system that offers drivers analog adjustment of steering rates as well as throttle and steering trim. The Shockwave's workmanship is equally impressive. The hull is professionally built from fiberglass and painted with the same technologies used in today's automotive finishes. Rubber motor mounts significantly reduce vibration and lengthen the hull’s life. There are no plastic parts on this boat. All the running hardware is stainless steel and aluminum, including the adjustable trim tabs that let drivers adjust the "ride" for varying wave conditions. Anti-skid fins, an oversized rudder and an adjustable strut for the Prather prop add even more ride-tuning options. This is high-octane RC offshore excitement at its best. Tech Notes To increase speed on calm water, bend the trim tabs up 1/4 to 1/2 inch with a pair of pliers. This will lift the front of the hull out of the water at high speeds, lower hull resistance and increase speed. This may however lessen the cornering ability. The trim tabs can also be adjusted individually to level the boat and compensate for engine and propeller torque. You can also increase top speed by removing the anti-skid fins, but you may experience reduced stability in rough conditions. Specifications
|
